Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Valley Village
If your chimney cap is missing, rusted through, or barely hanging on, and the crown above it looks cracked, you’re in the right place. Chimney cap and crown work in Valley Village usually runs $600-$2,400 depending on whether the crown needs coating or a full rebuild and whether the cap is a single-flue model or a custom multi-flue cover. We handle both, and we know this housing stock well: the ranch and mid-century homes on these lot-and-block streets have original masonry chimneys that take a beating from the sun and sit idle most of the year. Call (844) 968-2733 and we’ll set up a visit. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

Why Valley Village Homeowners Call Chimney Sweep Tujunga for Chimney Cap & Crown
We’re a full-system chimney company, which matters because cap and crown problems rarely show up alone. Most calls start with one visible issue and turn into a conversation about the flue liner, the smoke chamber, and the firebox once we’re on the roof. We’re authorized to source and install components from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, so the cap on your chimney is a fitted, manufacturer-grade piece rather than a hardware-store cover that gets strapped on and blows loose in the first Santa Ana wind event.
What we find in Valley Village specifically is that the crown is usually the real problem, not the cap. Intense summer sun bakes the masonry, the rainy season pushes moisture into the hairline cracks it leaves behind, and the cycle repeats until water is getting into the smoke chamber. Our technicians have up to 9 years of experience reading that kind of damage and telling you honestly which parts need work now and which can wait. We work with an industry-vetted roster of brands for that reason: durability first, cost second.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Valley Village
A crown that’s failing and a cap that’s missing are two halves of the same water problem. Here’s how we handle each piece, and why we treat them together.
Crown Repair in Valley Village
The chimney crown is the concrete or mortar cap at the very top of the stack, and it’s the part that takes the most sun in Valley Village. When it cracks, water runs straight down through the masonry and into the smoke chamber. Repair means removing the failed material, re-forming the crown with a proper slope so it sheds water, and bonding it to the flue. On original 1950s and 60s masonry fireplaces, we often find the crown has never been touched.
Crown Coating
Not every crown needs to come off. When the damage is surface-level cracking rather than a structural break, a crown coating seals the masonry and buys you years before a rebuild is necessary. We use HeatShield products for this kind of resurfacing work, which is a capability most single-service sweep companies don’t have. If a coating will hold, we’ll tell you. If it won’t, we’ll show you the photos.
Cap Installation in Valley Village
A proper chimney cap keeps rain out of the flue, keeps birds and squirrels from nesting on the smoke shelf, and sparks from landing on the roof. On a Valley Village ranch home with an original brick fireplace, a single-flue Gelco cap sized to the flue opening is usually the right fit. We fit the cap to the actual flue, not to a generic measurement, because a loose cap is worse than no cap in a wind event.
Multi-Flue Caps and Custom Caps
Larger two-story rebuilds and duplexes along the main corridors in Valley Village often have more than one flue running up the same stack. A multi-flue cap covers the whole chimney top in one unit, which keeps weather and animals out of every flue at once. Custom caps are for the odd chimney that doesn’t match a standard size. Both are worth pricing out before you commit to a single-flue solution on a multi-flue chimney.
Trusted Brands We Service in Valley Village
We source and install cap and crown materials from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield. That matters more than it sounds. A chimney cap is a specific product with a specific flange, mesh rating, and mounting method, and the right one depends on your flue size, your chimney’s shape, and whether animals or weather are the bigger threat. We don’t claim to keep parts on a truck or stock a warehouse in Valley Village. What we do is specify the correct manufacturer part for your chimney and get it fitted, so the first call is also the last one.

Common Chimney Cap & Crown Problems We See in Valley Village Homes
- Cracked crowns from sun and rain cycling. Intense summer heat on old mortar followed by rainy-season damp is the single most reliable way to crack a masonry crown in Valley Village. Water then runs into the smoke chamber and starts eating the joints from the inside.
- Dormant flues turned into nesting habitat. Because these fireplaces see little steady fire use, the flue stays dry and open for months. That’s prime real estate for birds and squirrels, and a nest jammed on the smoke shelf will block your draft completely.
- Missing or rusted caps on original 1950s-60s masonry fireplaces. Many of these chimneys have gone decades without a sweep and without a cap. A Level 1 or Level 2 inspection often turns up spalling brick and a deteriorated crown sitting under a cap that rusted out years ago.
- Decades of deferred inspection. When a fireplace goes years between fires, nobody looks at the chimney. Small crown cracks become big ones, and by the time the fireplace is used again, the water damage is already done.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Valley Village, CA
Most cap and crown jobs in Valley Village fall into a range you can plan around. A standard single-flue cap installation typically runs $250-$450. A multi-flue or custom cap runs $500-$950, since the unit has to cover the whole stack and often needs custom sizing. Crown coating, when the damage is surface-level, usually runs $400-$750. A full crown rebuild, where the old crown is removed and re-formed with a proper slope, typically runs $900-$2,400 depending on the chimney size and access. These are estimates for this market, and the written estimate you get after the inspection sets the final price. We don’t add a trip charge or a diagnostic fee, and nothing gets recommended without photos or camera footage you can look at yourself. If the work can safely wait a season, we’ll say so.
| Service | Typical Estimated Range in Valley Village |
|---|---|
| Single-flue cap installation | $250-$450 |
| Multi-flue or custom cap | $500-$950 |
| Crown coating | $400-$750 |
| Full crown rebuild | $900-$2,400 |
If you want a straight answer on what your chimney actually needs, call (844) 968-2733. Estimates are free, and we’ll show you what we found.
We Also Serve Cities Near Valley Village
We work across the surrounding area as well, so if you’re just outside Valley Village we can still help. Our chimney cap & crown team covers Valley Village, North Hollywood, Toluca Lake, Sun Valley, and Burbank. The housing stock in those neighborhoods is similar enough that the same crown-and-cap diagnosis usually applies, though each block has its own quirks. Call and we’ll confirm coverage for your address.
Serving Valley Village, CA – Our Local Coverage Area
We serve Valley Village and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Valley Village
Because the damage comes from sun and rain, not from fire. A fireplace that sits dormant for months still has a crown exposed to intense summer heat and rainy-season damp, and that cycling cracks the mortar whether you’ve had a fire or not. Call (844) 968-2733 for an inspection and an exact quote. Estimates are free.
A single-flue cap sized exactly to the flue opening, made from a rust-resistant manufacturer-grade product, is usually the right fit. On these original masonry fireplaces, the flue is often an odd size that a generic hardware-store cap won’t seal properly. We fit Gelco and Famco caps to the actual flue, not to a standard measurement. Call (844) 968-2733 and we’ll price it for your chimney.
Once a year is still the right interval, even with light use. The risk here isn’t creosote buildup so much as animals nesting in a dormant flue, crown cracks letting water in, and masonry spalling quietly under a cap nobody’s checked. Annual inspection catches those early. Call (844) 968-2733 to book one.
Yes. A cracked crown lets water into the smoke chamber and mortar joints, which damages the flue structure and can change how the chimney draws. A clogged smoke shelf from a bird or squirrel nest will block draft outright. Either one can make a fireplace smoke into the room even when the flue itself is clean. Call (844) 968-2733 for an inspection and a straight answer.
Look for someone who inspects the whole system, not just the cap. The cap is the last five inches of a chimney that runs the full height of the house, and the crown underneath it is usually the real issue. Ask whether they carry manufacturer-grade caps, whether they can do crown repair and coating, and whether they’ll show you photos of what they found. We do all of it. Call (844) 968-2733 for a free estimate.
What Happens When You Call
A call gets you booked for a visit, not a sales pitch. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. On the visit, a technician inspects the crown, the cap, the flue, and the smoke chamber, then gives you a written estimate with photos so you can see exactly what needs work and what doesn’t. Because we handle inspection, sweeping, cap and crown work, and chimney and fireplace repair under one roof, you won’t need a second contractor when a problem turns up. Call (844) 968-2733 for a free estimate.
Written by the team at Chimney Sweep Tujunga.